PreFRED Board simulation with QUICKSIM-II

Introduction

The PreFRED board has been fully simulated with QUICKSIM-II of Mentor Graphics. The project has been done on a UNIX workstation in the Electronics Development Group of The University of Chicago. The several QSIM setup files are in the /design/CDF_L1/final_PreFRED/PreFRED2/setups/... directory.

QSIM Results

  1. SUMET Board: Simulation of the board with the processor chip configured for SUMET.
    1. 0~3500 nsec: Writing of control registers and trigger thresholds.
    2. 0~7000 nsec: Reading of control registers and trigger thresholds.Enter run mode.
    3. 7000~10500 nsec: B0 comes and data starts to enter the FIFOs.
    4. 10500~140000 nsec: Reading the DAQ buffers.
    5. 14000~17500 nsec: Same.
    6. 17500~21000 nsec: Same
    7. 21000~24500 nsec: Same.
    8. 24500~28000 nsec: Halt.
    9. 28000~31500 nsec: Writing and reading of LUTs.
    10. 31500~35000 nsec: Writing and reading of LUTs; Run; New B0.
  2. TOWTRG Board: Simulation of the board with the data processor configured for TOWTRG.
    1. 20500~28200 nsec: coming soon.
  3. MUON Board: Simulation of the board with the data processor configured for MUON.
    1. 20500~28200 nsec: coming soon.

    Aditional information

    Please contact Mircea Bogdan (bogdan@impulse.uchicago.edu) .

     

 
For questions regarding this page contact Mircea Bogdan.
bogdan@impulse.uchicago.edu
Revised: August 9, 1999